Description

EAST HAM

251/0/10090 JENKINS LANE
04-MAR-09 BECKTON
Chimney to Beckton Sewage Works

II
Chimney, 1887-9, by Sir Joseph Bazalgette for the Metropolitan Board of Works. Minor later alterations.

Originally one of two chimneys, this is a round, tapering brick structure with a limestone cap in an Egyptian design with fluting and a patterned frieze. There were once steps next to the chimney giving access to the inside but these have been covered or removed.

HISTORY: When the Metropolitan Board of Works (MBW) pioneered London's sewage system in the years from 1848, Beckton was designated as the drainage outfall for sewers north of the Thames, with equivalent works at Crossness serving the area south of the river. Built 1859-1868 to designs by Joseph Bazalgette, the new sewage system was one of the foremost engineering achievements of the Victorian era and included the construction of the Thames Embankment with a tunnel for the Underground, an extensive system of cross-metropolitan drains and a series of pumping stations, designed to remarkably high architectural and technical standards. North of the river, all of inner London's sewers met at Abbey Mills pumping station near Stratford, from where waste was pumped to a sufficient height to allow gravity to draw it away to Beckton. Here, waste was released untreated into the Thames at high tide, or stored in a reservoir at low tide. Beckton was at that time the ideal location for the Northern Outfall, as it was known, because it was quite far downriver from the capital and relatively uninhabited. In the two decades after the works opened in 1863, however, London expanded geographically and demographically. The volume of raw sewage being poured into the Thames, not even separated into liquid effluent and solid waste, increased and responsibility to remedy the problem fell to the MBW. Thus in 1887 Bazalgette designed sewage treatment works for Beckton comprising liming station and precipitation channels (to separate liquid from solid), settlement channels (to consolidate sludge), storage tanks and a jetty in the Thames (from which the solids were transported to be dumped out at sea; the cleansed liquid was discharged into the Thames). The pumping station at Crossness was adapted for this process at around the same time. The work was completed by 1889.

At the centre of operations on the Metropolitan Board of Works' Beckton site was the engine house, two boiler houses and two chimneys which powered the machinery involved in moving the sludge through the treatment process. In addition there was a workshop, attached to the engine and boiler houses, also dating to the 1887-9 phase of work. In the 1890s an overhead storage tank was built above the settlement channels and in the Edwardian period an additional boiler house was constructed; both likely responding to a need to increase capacity at the works.

REASONS FOR DESIGNATION: The chimney at Beckton Sewage Works is listed at Grade II for the following principal reasons:
* architecturally special for its elegant tapering form and Egyptian-style cap;
* designed by Sir Joseph Bazalgette as part of improvements to the Northern Outfall of his London drainage network in 1887, in response to public health concerns;
* it identifies Beckton as a Victorian industrial site;
* a striking landmark in the landscape of East London, where the distinctive Greenway embankment (the original main drain) runs from the Grade II*-listed Abbey Mills pumping station to Beckton Sewage Works.

Reasons for Listing

The chimney at Beckton Sewage Works has been listed at Grade II for the following principal reasons:
* architecturally special for its elegant tapering form and Egyptian-style cap;
* designed by Sir Joseph Bazalgette as part of improvements to the Northern Outfall of his London drainage network in 1887, in response to public health concerns;
* it identifies Beckton as a Victorian industrial site;
* a striking landmark in the landscape of East London, where the distinctive Greenway embankment (the original main drain) runs from the Grade II*-listed Abbey Mills pumping station to Beckton Sewage Works.

External Links

• Historic England Listing
• Wikidata Q26672344

External links are from the relevant listing authority and, where applicable, Wikidata. Wikidata IDs may be related buildings as well as this specific building. If you want to add or update a link, you will need to do so by editing the Wikidata entry.

Recommended Books

• 
  This Old House: Restoring, Rehabilitating, and Renovating an Older House
• 
  Hampshire: Winchester and the North (The Buildings of England) (Pevsner Architectural Guides: Buildings of England)
• 
  Specifications for Building Conservation: Volume 1: External Structure: Practical Examples v. 2
• 
  Department for Communities Listed Historic Buildings of Northern Ireland: Information Guide for the 2nd Survey of Historic Buildings
• 
  Hampshire: South (Pevsner Architectural Guides: Buildings of England)
• 
  Surrey (The Buildings of England) (Pevsner Architectural Guides: Buildings of England)